Hubbell Switch LHIR User Manual

LightHawk Wall Switch Occupancy Sensors  
Installation and Operating Instructions  
Hubbell Building Automation, Inc.  
9601 Dessau Road, Building One, Suite 100  
Austin, Texas 78754  
512-450-1100 • 512-450-1215 Fax  
Wiring Diagram  
Range Diagram  
Description  
e LightHAWK is an intelligent self-adapting occupancy sensor that is  
designed to replace existing wall switches.  
Specifications  
• 1000 sq. ft coverage area (Models: LHIR and LHMT)  
• 400 sq. ft. coverage area (Models: LHUS)  
• Single or Dual circuit 120/277VAC, 50/60Hz operation  
• Electrical Ratings: (Each Output Separately)  
120VAC – 800W Incandescent, 1000W Ballast, 1/6 HP  
277VAC – 1800W Ballast, 1/6 HP  
• Adjustable Time Delay: 4-30 minutes, self-adapts based  
on occupancy  
• Light Level Adjustment (Circuit B output on Dual Circuit versions):  
10-500+FC  
• ETL listed (Conforms to UL STD 508 Certified to CAN/CSA STD  
C22.2 No. 14)  
Precautions  
CAUTION: RISK OF ELECTRICAL SHOCK. Turn power off at  
service panel before beginning installation. Never wire energized electrical  
components.  
Read and understand all instructions before beginning installation.  
NOTICE: For installation by a licensed electrician in accordance with  
National and/or local Electrical Codes and the following instructions.  
NOTICE: For indoor use only.  
CAUTION: USE COPPER CONDUCTOR ONLY.  
Confirm that device ratings are suitable for application prior to installation.  
NOTICE: Do not install if any damage to product is noticed.  
Sensor Operation  
Installation  
1. Turn power off at the service panel.  
2. Remove the old switch(es) if applicable.  
3. Wire as shown in the Wiring Diagram section. A secure connection  
to ground is necessary for the sensor to function properly.  
4. Install sensor in wall box using mounting screws provided.  
5. Restore power to the sensor and allow it to warm up (up to 2 min.).  
6. Remove the sensor’s cover – see Adjustments section.  
7. If desired, calibrate the photocell sensor and adjust the sensor’s  
configuration switch settings as described below.  
8. Reinstall the sensor’s cover.  
9. Install a Decorator style wall plate (not included).  
Test Mode – to enter test mode:  
1. Make sure lights are on.  
 

Graco Car Seat Child Restraint Booster Seat User Manual
Great Dane Lawn Mower GSRKA1934S User Manual
Grizzly Chainsaw Sharpener T23107 User Manual
Harbor Freight Tools TV Mount 68784 User Manual
HP Hewlett Packard Flat Panel Television LC3760N User Manual
HP Hewlett Packard Stereo Receiver VA 1809 User Manual
Huawei Cell Phone Y 201 User Manual
Icom TV Receiver AT 140 User Manual
IKEA Cooktop ICR416RB01 User Manual
Image Treadmill IMTL391051 User Manual