Instructions
XD Diesel Exhaust
Fluid (DEF) Hose
Reels
3A1767A
ENG
For use with Diesel Exhaust Fluid only. For professional use only.
Not approved for use in European explosive atmosphere locations.
Application markets include: mobile equipment servicing
and industrial plants.
Models: Page 3
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
ti13980
Warnings
WARNING
MOVING PARTS HAZARD
Moving parts can pinch, cut or amputate fingers and other body parts.
•
•
•
Keep clear of moving parts.
Do not operate equipment with protective guards or covers removed.
Pressurized equipment can start without warning. Before checking, moving, or servicing equipment,
follow the Pressure Relief Procedure and disconnect all power sources.
PERSONAL PROTECTIVE EQUIPMENT
You must wear appropriate protective equipment when operating, servicing, or when in the operating
area of the equipment to help protect you from serious injury, including eye injury, hearing loss,
inhalation of toxic fumes, and burns. This equipment includes but is not limited to:
• Protective eyewear, and hearing protection.
• Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.
Models
Each model shown in the table below is available in several colors. The last character of each model no. indicates the
hose reel color. A = white, B = Metallic Blue and F = Yellow. On the table below, this last character is represented by
the generic # symbol. For example, to show the complete model number for a white HSDD5# model hose reel, the
symbol # is replaced with “A”. The complete model number is: HSDD5A.
Maximum Pressure
Hose
Size
Model No.
Application
PSI
Bar
3.4
3.4
Mpa
HSDD5# Diesel Exhaust Fluid
HSDDD# Diesel Exhaust Fluid
3/4 inch
3/4 inch
50
50
0.34
0.34
3A1767A
3
Installation
Installation
A bleed-type master air valve (E), thermal relief valve (H) and fluid drain valve (J) are
required in your system installation. These (user supplied) components help reduce the risk of
serious injury.
•
•
The hose reel must be grounded.
The bleed-type master air valve (E) relieves air trapped between this valve and the pump
after the air is shut off. Trapped air can cause the pump to cycle unexpectedly, therefore
.
locate the valve close to the pump.
•
The thermal relief valve (H) and fluid drain valve (J) assist in relieving fluid pressure in the
displacement pump, hose and dispense valve. Triggering the dispensing valve (N) to relieve
pressure may not be sufficient. Open the fluid drain valve (J) to relieve fluid pressure that
may be captured elsewhere in the system.
Typical Installation Layout
J
A
C
K
H
E
B
F
D
M
G
L
N
FIG. 1
A
B
C
D
E
F
Main air supply
Pump air supply
Air regulator
Bleed-type master air valve (user supplied, required)
Pump
Grounding wire (user supplied, required for pump and
hose reel)
G
H
J
K
L
Fluid line
Hose reel
Dispensing valve
Air Supply Line
Nozzle Tray
M
N
Safety Valve (set to 50 psi (3.4 bar, 03.4 MPa)
Fluid Shutoff Valve
4
3A1767A
Installation
Pressure Relief Procedure
1.
2.
3A1767A
5
Installation
All Mountings
To reduce the risk of injury, be sure the mounting sur-
face and mounting screws are strong enough to sup-
port the reels, weight of the fluids and stress caused
by hard pulls on the service hoses. See Technical
NOTE: Reels perform best when arm allows hose to pull
FIG. 2
FIG. 3
6
3A1767A
|